22
XciteRC Rocket 125 3D
EN
Camera
·
Illumination
·
Landing
·
Maintenance
Press
Applying the camera (optional)
Make sure that the SD card is inserted in the camera. Otherwise the the camera is deactivated. Each tome
pressing the PHOTO button makes a photo frame, accompanied by a short beep. Press the VIDEO button,
the video recording starts, also the camera icon appears in the display, accompanied by a Di-Di sound and
the camera symbol in the display. Press the VIDEO button again to stop the recording.
2
3
%
L . H
E A S Y
Video
Photo
LCD Display
1
ON: Video recording
OFF: Video recording stopped
Illumination
Press the control lever to switch the lighting of the Rocket 125 3D on or off. Is the lighting on, a bulb appears
in the transmitter sreen.
1
2
%
L . H
E A S Y
LCD Display
Landing:
• Carefully push the left throttle lever rearward. Try to land „smooth“ without damaging the Quadrocopter.
•
NOTE:
if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.
WARNING:
the motor of the XciteRC Rocket 125 3D may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage.
Fire hazard!
Maintenance
To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
Summary of Contents for Rocket 125 3D 15006100
Page 13: ...13 XciteRC Rocket 125 3D DE...
Page 25: ...25 XciteRC Rocket 125 3D EN...
