XciteRC Rocket 125 3D 15006100, Manual

23

 XciteRC Rocket 125 3D

EN

Troubleshooting 

· 

Repairs

•  Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a 

harder brush or a toothbrush can be used.

•  To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic 

of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up 
liquid.

•  Check the tightness of all screws and tighten if necessary.
•  Also check all connections, cables and power battery / rechargeable battery for damage.

• 

 WARNING:

 Damaged batteries or rechargeable batteries must not be used again and must be 

disposed of immediately – 

fire hazard!

 Please note the disposal notes at the end of this manual.

•  Check the model for worn, broken or jammed parts and gears and repair if necessary.

• 

 WARNING:

 remove the batteries / rechargeable batteries of the transmitter and model when not in 

use – 

fire hazard!

Troubleshooting

Problem

Possible Cause

Corrective Action

Rotor don‘t move

ON/OFF switch is OFF
Weak Quadrocopter battery
Transmitter - model not bound

Switch ON Quadrocopter
Re-charge battery 
Rebind: first switch on the model, then the 
transmitter

Rotor stops sud-
denly, Quadrocop-
ter chrashes

Weak Quadrocopter battery
Weak transmitter battery

Re-charge battery
Change transmitter batteries

The Quadrocopter 
does not react to 
the remote control. 
Loss of control.

Gyro initialisation failure

Quadcopter not bound to the trans-
mitter
Gyro calibration failure after a crash

Place the model on a flat surface when 
switching on
Re-bind: switch on the quadcopter first, 
then the transmitter
Re-calibrate the gyro, see section: Get-
ting Started, gyro calibration

The Quadrocopter 
flies uncontrollably

Gyro calibration failure after a crash

Re-calibrate the gyro, see section Getting 
Started, gyro calibration

Repairs, Spare Parts

Normal wear and defective parts that result from an accident, are excluded from the guarantee. These in-
clude in particular:

For car models:

 bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork

For ship models:

 damaged or broken propellers, torn superstructure

For airplanes:

 damage due to improper transportation or crash

I If you find a part that is defective in material or workmanship right after opening the package, return - before 
you used it – to your dealer or directly to us and we will send you a replacement.
For the Rocket 125 3D some parts are available as spares. If a part is defective or worn, you can identify it 
with the help of the online spare parts list.
In case of problems or questions, please contact your dealer or:

XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 7161 
40 799 50
Email: service@xciterc.de
Spare parts for the XciteRC Rocket 125 3D you may order in your local hobby shop or online at http://www.