19
XciteRC Rocket 55 Cam
EN
Getting started
• Connect the USB cable to a PC or appropriate power supply.
• Connect round plug with the Quadrocopters charging socket.
• The red LED goes on to indicate charging. Charging time is about 30 minutes. If the battery is fully char-
ged, the red LED goes out again.
• Unplug the battery and the USB cable.
The flight time of the Quadrocopter is about 4-5 minutes.
Getting started
Before you begin please check:
•
WARNING:
Only start with a sufficiently full transmitter batteries and fully charged Rocket 55 battery
–
crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
(Fig. 1)
(Fig. 2)
(Fig. 3)
the green LED points
away from the pilot
Camera
• Move the throttle lever in the lowest position (Fig. 1).
• Switch the Quadrocopter on, the LED‘s starts flashing.
• Switch on the transmitter. The POWER LED flashes.
• Place the Quadrocopter in the starting position and move the left throttle lever all the way up (Fig. 2) and
then back in the lowest position (Fig. 3). This safety circuit prevents the rotor may start after turning ON
the Quadrocopter.
•
NOTE:
Throughout the switching-on the Quadrocopter must be placed on a flat surface, because it
also initializes the gyro during this process. If this is ignored, the model will not fly properly and is hard to
control.
In this case, turn everything off and start again from step 1.
• The model is ready to fly as soon as the „DI-DA-DO“ melody is heard. The POWER LED of the transmitter
lights up solid red, also the LED‘s of the model stops flashing and lights up solid.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the Quadrocopter sinks automatically. Find
a suitable place to land safely. Charge the flight battery again.
