20
Sand Storm one10
EN
The remote control system
·
Binding
Transmitter
A: Steering wheel: direction right or left
B: Throttle trigger: controls the speed and direction of the model
C: Battery compartment
1. Control trim: adjusts the straight ahead driving
2. Servoreverse steering
3. POWER LED: indicates the battery voltage
4. On / Off Switch: Turns the power of the transmitter ON / OFF
5. Steering Dual Rate: sets the maximum curve radius
6. Throttle trim: adjust the neutral position of the controller (always in the middle position!)
7. Servoreverse throttle
8. BIND-LED: indicates a “bound” receiver
9. BIND (pair)-button
NOTE:
the adjuster for the throttle trim TH.TRIM and the servo reverse switches for steering ST.REV
and throttle TH.REV must not be adjusted. So check the correct position before every ride: throttle trim to the
center position (mark on the adjuster points up), steering reverse: switch in position N, servo reverse throttle:
switch in position R.
BINDING
The 2.4 GHz receiver of Sand Storm one10 must be once „connected“ with a suitable transmitter, the so-
called „binding“ procedure. This ensures that the receiver establishes a connection only with this transmitter
and the model can be operated without interference. This process can be repeated any time.
The transmitter and receiver of the Sand Storm one10 are already bound so that you can start fl ying immedi-
ately. Should a rebind gets necessary (eg. after a transmitter change), proceed as follows:
g
g
4
ON
+
A
B
C
5
6
7
8
9
1
2
3
4
Summary of Contents for Sand Storm one10 30300000
Page 15: ...15 Sand Storm one10 DE ...
Page 41: ...41 Sand Storm one10 FR ...
