25
Sand Storm one10
EN
Troubleshooting
Servo installation
Troubleshooting
Problem
Possible Cause
Solution
Motor does not run
Motor cable unplugged or broken
Drive battery empty
Throttle trim TH.TRIM on the transmitter set
incorrectly
Motor broken
Insert the motor cable or solder
Change or charge the battery
Check transmitter, set trim correctly
Replace the motor
Vehicle runs back-
wards
Throttle servo reverse switch TH.REV in R
position
Set servo reverse switch in position N
Weak motor / no
power
Battery is almost empty
Throttle trim TH.TRIM on the transmitter set
incorrectly
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Change or charge the battery
Check transmitter, set trim correctly
Check drive train and clean if necessary
Check pinion clearance, adjust if necessary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Vehicle is hard to
control
Transmitter LEDs fl ashing - transmitter bat-
teries almost empty
Steering trim ST.TRIM on the transmitter set
incorrectly
Interference
Throttle trim TH.TRIM on the transmitter set
incorrectly
Change or charge the battery
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make a
quick break and then re-try
Set throttle trim to the center position
Vehicle has no
function
LEDs on the transmitter does not light up
Transmitter - receiver not bound
Interference
Throttle trim TH.TRIM on the transmitter set
incorrectly
Car aerial torn off
Transmitter LEDs fl ashing - transmitter bat-
teries almost empty
Drive battery empty
Check that vehicle and transmitter are tur-
ned on
Rebind transmitter - receiver (see chapter
BINDING)
Set throttle trim to the center position
Repair antenna (vehicle)
Change or charge the battery
Change or charge the battery
Vehicle runs very
loud
Gear mash between the pinion and main
gear set incorrectly
Worn gears
Bearings runs tight or worn out
Check gear mesh adjust if necessary
Check and replace if necessary
Check and lubricate or replace if necessary
Summary of Contents for Sand Storm one10 30300000
Page 15: ...15 Sand Storm one10 DE ...
Page 41: ...41 Sand Storm one10 FR ...
