17
X-Dive micro U-Boot
EN
Getting started
·
RC functions
Getting started
Switching on:
WARNING:
Close the waterproof switch cap of the submarine completely before putting under water -
risk of sinking!
Waterproof
Switch Cap
close
Outlet
Close
completely
Green light
Yellow light
• Close the waterproof switching cover completely.
• The lighting goes on, the boat is now ready for operation.
• Hold the back of the submarine and put the front into the water, then shake it a few times according the
illustration. Then release it completely in the water.
•
WARNING:
Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery –
crash hazard!
RC functions
Dive
• Press the dive button to dive with the submarine. Through the dip tank, the boat can processed on the
spot and reappear.
• With some skill the boat can be kept on a certain dive depht by alternately filling or emptying the ballast
tanks while driving.
• If the boat loses balance while driving and sinks uncontrollably, there is probably some water in the sub-
marine. To release it, open the under-side outlet. The water is removed by shaking the boat.
Outlet
•
WARNING:
close the under-side outlet carefully –
risk of sinking!
• Does the submarine did not dive at all, tip it upside down into the water according the illustration and
gently move a few seconds. Then completely leave the water. It will turn itself after a short time and is
then ready for use.
Summary of Contents for X-Dive micro U-Boot U-18
Page 11: ...11 X Dive micro U Boot DE ...
Page 30: ...30 X Dive micro U Boot ...
Page 31: ...31 X Dive micro U Boot ...