Ⅵ
.How to set up the composed key function:
XCM FPS Programmer has 6 built-in Memory keys (M1~M5 and C), each Memory key can store up
to 8 commands for using on composed key.
Note: The Memory key setting only works on 360 wired controllers, after the settings are saved, you
can connect the PS3
TM
controller to use the Memory key functions.
For instance: If you want to map 4 keys (A, B, X, Y) working together on (A) key (as composed key)
the same time, that means when you press the A key, it will operate A, B, X, Y keys at the same time,
and save this setting into the M1<5> Memory key, the steps are shown below:
1. Press down the P button on the device, the P LED indicator <7> lights up.
2. Press the M1 button (on the device) ,the M1 LED indicator lights up.
3. Press the A, B, X, Y keys on your controller, the A, B, X, Y keys lights up in order; the XCM FPS
Programmer will store the setting in sequence and the length of pressing time. (Some actions may
take 1-2 seconds to complete, in this case, if B key is acted as prone, it may take 2 seconds, you will
need to press the B key for 2 seconds to set this motion).
4. Now press the M1 button again. The M1 LED indicator blinks.
5. Finally press the A key on your controller. The A, B, X, Y LED indicator light turns off. If the M1 LED
indicator is ON, the setting is complete. (A key is now acted as the composed key)
After setting the above settings, you can operate this setting with 2 modes.
Mode A – All mapping keys work synchronized.
Mode B – All mapping keys work in sequence according to the length of the pressing time.
How to use the 2 composed key modes (Mode A and Mode B).
