XE210C Hydraulic Excavator
Operating and Maintenance Manual
142
Note: in the cold weather, be sure to heat the machine before loading/unloading it.
Transport
Note: tie the chain or rope to the frame of machine, and don’t make the chain or rope pass
through or pressed on the hydraulic pipe or hose.
a)
Place the damp blocks before and behind the crawler to fix the machine.
b)
Fix four corners of machine and front-end working device to the trailer with a chain or rope.
Unloading
Note: make the intersection of trailer platform rear end and slope convex, and drive the
machine by it carefully.
I
mportant: avoid any possible damage of front-end working device. During the unloading, keep the
angle between the bucket rod and movable arm within 90° to 110º always, retract the bucket rod, and
any unloading may cause the damages to machine.
a)
Upon moving the tail end of machine through the trailer to the slope or platform, support the bucket
plane on the ground, and make the angle between bucket
rod and movable arm within 90º to 110º.
Important: avoid any possible damage of hydraulic
cylinder, and avoid any fierce collision of bucket to
the ground.
b)
Place the bucket on the ground before the machine starts
to incline forward.
c)
During the forward movement of machine, lift the
movable arm and stretch the bucket rod until the
machine drives fully under the slope or platform.
●
Lifting method of machine
Note:
1)
Lifting steel rope and other lifting tools may be
broken, which results in the serious injury of person. Don’t use any damaged or aged steel rope
or lifting tool.
2)
For correct lifting methods, types or sizes of lifting steel rope and lifting tools, contact with the
assigned dealer.
3)
Pull the safety locking rod to LOCK (lock), and avoid any unexpected movement of machine
during the lifting.
4)
Incorrect lifting methods and incorrect mounting of steel rope will cause the movement of
machine during the lifting, which results in the damages to machine and injuries to the persons.
5)
Don’t lift the machine rapidly, otherwise the lifting steel rope and lifting tools will be
overloaded and may lead to their fracture.
6)
Don’t let any person approachable to the lifted machine or walk under it.
7)
The gravity center marked on the machine is for the machine of standard specifications, but the
actual gravity center will be changed as per the type of installed accessory or chosen device and
their position. Therefore, ensure the balance of machine can’t be lost in case of lifting the
Fig. 3-5
Fig. 3-6
