English
5
5. OK: Enter button
6. RIGHT: Right selection (Single
press or long press on this
button for fast forward)
7. DOWN: Down selection (A
long press on this button can
turn the volume down. In MP
playing state, a single press on
this button can select the next
music)
8. BACK: Return button
9. MENU: Menu button
10. POWER: Press this button and
hold for seconds, PMP will be
turned on. Press this button and
hold for seconds and PMP will
be turned off
12. HOLD button: Used for button
lock control in main body of
PMP
1. Reset button: Used for reset
operation
Top side
14. MIC: Used in digital audio
recording
15. SD storing card slot
Left side
16. Earphone output port: Used for
output of stereo sound
17. USB 2.0 full speed port: Used
to connect PMP with digital
devices.
18. Line in port
2. Introduction to other acces-
sories:
AC adaptor
• Only special charger/adaptor
of XCube accessories shall be
used
• Prior to initial application, the
battery shall be charged for
more than four hours
Mode for PMP may select corre-
sponding cable.
1)When PMP is used as OTG Host
(digital mate):
When PMP is used
as main device, USB_Host cable
connects PMP with digital devices
such as U-disc and digital camera.
Upon connection, data in digital de-
vices such as U-disc can be trans-
mitted to PMP flash disc.
Method of operation: Turn on PMP,
enter “Setup” menu through main
menu. Select “System”, and for USB
operation mode select “OTG Host”.
Move cursor to “Enter” button and
then press “OK” button on panel or
remote controller to enter setup.
Connect digital devices such as
501IM.indd 5
30.03.2007 12:26:52