DO NOT RETURN TO RETAILER YOU PURCHASED AT.
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or service@xdp-recreation.com
9
ASSEMBLY INSTRUCTIONS
Place the LAWN SWING FRAME on level ground and not less than 6ft
(1.8m) from any structure or obstruction such as a fence, garage,
house, overhanging branches, laundry line, or electrical wires.
Do not install the LAWN SWING FRAME over concrete, asphalt, packed
earth, or any other hard surface; a fall onto a hard surface can result in
serious injury or death to the equipment user.
Adequate overhead clearance is essential.
A minimum clearance from
ground level shall be recommended. Provide clearance for wires, tree limbs,
and other possible hazards.
TIGHTENING NUTS & BOLTS
For ease of installation, do not over-tighten the nuts and bolts when
you are first putting the equipment together. This will allow for some
possible adjustments during installation.
Once you have finished assembling each component of the play set,
make sure to go back over each step and properly tighten all nuts,
bolts and plastic caps. Check the entire unit to ensure all parts are
properly assembled before allowing children to use the playground
equipment.
