Cymbal Installation
1. Remove the Wing Nut, Washer and Felt
①
from the top
of the rod.
2. Put Cymbal Pad
②
into the Rod
③
, then place back
parts removed in the step 1. Fasten the wing nut but not
too tightly. It allows the pad a little bit wobbling like real
acoustic cymbal.
6
Tom Installation
1. Loosen Pad Connector
①
, insert
Hex Rod
②
, and tighten Pad
Connector
①
.
2. Loosen the wing nut under Drum
Pad
③
, and insert it to Hex Rod
②
.
3. Adjust to suitable position and
fasten wing nut under Drum Pad
1.
Install Kick Legs
①
on both sides
and then fasten the wing nut.
2. Insert Kick Pedal
②
to Kick Drum,
adjust the pedal to suitable position and
then fasten wing nuts on the pedal.
Kick Installation
①
②
③
①
②
1. Align holes in the sound module and the model mount then insert
screws and fasten it.
2. Insert rod of the model mount into the clamp, then tighten the wing nut.
Sound module Installation
Finalizing the Installation
After install all components, fine adjust the arm, clamps and rods to the
best position you desire.
Electronic Connection
Connect the trigger connector cable plug to the bottom of the sound
module, and then connect all cable heads according to their name tags.
INSTALLATION
DRUM
INSTALLATION -
2
①
②
③
