5
Snare Installation
1. Open Snare Stand Legs
①
to suitable
position and make it stand firm.
2. Open Snare Stand Arms
②
, stretch it to
maximum, put the Snare upward on the stand.
The one with rubber band and white sensor spot
is the upside.
3. Tighten Snare Stand Arms
②
by rotating
the rotary on the bottom side
②
①
HiHat Installation
1. Open HiHat Stand Legs
①
to suitable position and
make it standfirm.
2. Insert Thin Rod
②
into screw thread on the Bottom
Stand according to dashed line here, and rotate it
clockwise to fasten it.
3. Place Hollow Rod
③
outside Rod
②
, and insert it into
Bottom Stand.
4. Insert HiHat Cymbal Tray
④
onto Thin Rod
②
and place
it aboveHollow Rod
③
5. Adjust Hollow Rod
③
to suitable height and fasten
it. Insert HiHat Cymbal onto Thin Rod
②
. Make sure there is
enough space between the Cymbal and Tray
④
, and then
fasten the screw on Cymbal.
Note:
If there is not enough space between Cymbal
and Tray
④
, the HiHat control function will be very short in
range or even notresponding.
①
②
③
④
⑤
INSTALLATION
DRUM
INSTALLATION -
1
