Resolute User Manual Version 2.5
33
Avoid overlapping base coverage boundaries.
Radio Configuration
The radios as configured from the factory will work for a single Base, multiple Rover RTK network.
If a NorthStar Repeater was included in your order, the Rovers will be configured to receive from
a single NorthStar. Multiple NorthStar Repeaters in series will require reconfiguration of the
Rovers.
To configure the radio channel on a Resolute use the command:
$RadioSetChannelid
[identifier]
[channel]
The identifier for a Resolute is always “A” and is not case sensitive. The ‘channel’ is a value
between and inclusive of 0 and 7.
To configure the radio to broadcast or receive on channel 7 the following command would be
sent.
$RadioSetChannelid
A
7
Configuring the Cell Modem
If a cell modem is installed in your unit, it needs a micro SIM from a local carrier to operate. See
details in
. The cell modem also requires setting the APN (Access
Point Name) specific to the plan you procured from your local carrier. This can be set with
$cellsetAPN [APN] . For instance for Bell data plans in Canada, the APN is
$cellsetAPN pda.bell.ca
The device should be reset after updating the APN. It is also a good idea to enable and disable
SMS or Data features depending on the plan and your intended usage. The Tunnel and XBD
require a Data plan.
Note: SMS is currently only functional for North American phone numbers.
