DOCUPRINT 96/4635/180 IPS MESSAGES
2-40
XEROX DOCUPRINT IPS MESSAGES GUIDE
09-222
Too short of time between belt holes.
The belt hole sensor made six unsuccessful attempts to detect belt
holes within the required spacing.
Action
Open the doors of the printer, clear areas 4, 5, 6, and 7, close the
doors, and retry the operation.
09-320
Dev rolls 1 & 2 bias out of range.
The monitor voltage for dev rolls 1 and 2 is less than the control
voltage.
Action
Press the or [Reset] button located behind the printer control console
front pull-down cover.
09-321
Dev rolls 3 bias out of range.
The monitor voltage for dev roll 3 is less than the control voltage.
Action
Press the [Reset] button located behind the printer control console
front pull-down cover.
09-322
Cleaner voltage out of range.
The monitor voltage for the cleaner brush is less than the control
voltage.
Action
Press the [Clear] button on the printer control console screen. Then
press the [Continue] button.
09-323
UDT roll bins volts out of range.
The monitor voltage for the upper detoning roll (UDTR) is less than
the control voltage.
Action
Press the [Reset] button located behind the printer control console
front pull-down cover.
09-324
LDT roll bias bolts out of range.
The monitor voltage for the lower detoning roll (LDTR) is less than the
control voltage.
Action
Press the [Reset] button located behind the printer control console
front pull-down cover.
09-325
Charge 2 voltage out of range.
The monitor voltage for the Charge 2 Shield is less than the control
voltage.
Action
Press the [Reset] button located behind the printer control console
front pull-down cover.
