DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
3-24
XEROX DOCUPRINT IPS MESSAGES GUIDE
H014
Shared line failure.
The CPM cannot communicate with any of the system boards and
the PHR cannot communicate with the MIR. In general, this indicates
that there is a short in the shared line network.
Action
Press the [Continue] button. If the error persists, contact your service
representative.
H015
CDM board communication failure.
The CDM cannot communicate with any of the system boards.
However, the PHR can communicate with the MIR.
Action
Press the [Continue] button. If the error persists, contact your service
representative.
H017
PHR failed memory/communication test.
The PHR memory and communication test was unable to complete
successfully.
Action
Press the [Continue] button. If the error persists, contact your service
representative.
H018
MIR failed memory/communication test.
The MIR memory and communication test was unable to complete
successfully.
Action
Press the [Continue] button. If the error persists, contact your service
representative.
H019
XER failed memory/communications test.
The XER memory and communication test was unable to complete
successfully.
Action
Press the [Continue] button. If the error persists, contact your service
representative.
H029
Invalid Belt hole detection.
A belt hole was not detected.
Action
Press the [Continue] button. If the error persists, contact your service
representative.
H031
Fuser over temperature fault.
The temperature of the fuser has risen above the acceptable
parameters (over 435 degrees F).
Action
Press the [Continue] button. If the error persists, contact your service
representative.
