SOLVING PROBLEMS
•
The number displayed in the Wire Percentage indicator of the
printer control console begins to flash.
This happens when the percentage of wire remaining on the
spool reaches a point set by your service representative.
Once the flashing begins, the following messages appear on
the printer control console when you start a new print job:
READY TO PRINT
STITCHER LOW ON WIRE
PRESS
i
TRAINED OPERATOR REPLACE WIRE
SPOOL OR CALL SERVICE
i
JOB IS PRINTING --
STITCHER IS LOW ON WIRE
Add stitcher wire or contact your Xerox Service
Representative to add wire, as soon as practical. Refer to the
“Adding stitcher wire” section in the “Print job maintenance”
chapter for further information.
•
The last few printed sets are not stapled. One of the
following situations has occurred:
— The stitcher/stacker is out of staple wire (indicated by
fault code L152 in the print quantity display of the printer
control console).
— There is a stitch wire jam (indicated by fault code L172 in
the print quantity display of the printer control console).
— There is a malfunction of the staple head (indicated by a
number of possible fault codes in the print quantity
display of the printer control console).
Contact your supervisor or your service representative. Until
the problem is resolved you may continue printing the job
without stitching the output.
•
The printer control console displays the following message:
OFFSET FAILED, SET IN OUTPUT BIN NOT OFFSET
However, the printed sheets in the stitcher/stacker tray are
offset normally. This situation may indicate a faulty
component in the offsetting mechanism of the stitcher. Call
service for further assistance. Clear the message by pressing
the Continue button on the printer control console.
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE
8-19
