HARDWARE COMPONENTS
Optional printer components
There are four options available with the LPS printer:
•
Dual stacker configuration
•
High-capacity stitcher/stacker configuration
•
High-capacity feeder configuration
•
Bypass transport.
Dual stacker configuration
The dual stacker configuration offers two output trays with the
ability for automatic tray switching. This allows you to program
the system to route output to the inactive output tray when the
active output tray is full. This feature allows you to unload a tray
without any interruption to the printing process as long as an
output tray is ready. If the inactive output tray is not ready when
the active output tray reaches its capacity, the system stops
printing. You can continue normal processing once an output
tray is ready.
You can select either output tray. If both trays are in the ready
mode, and neither is selected manually, the system selects tray 1.
You can change your tray selection at any time, provided the
alternate output tray is in the ready mode.
You can also select one of the output trays as the sample tray,
except when you use transparencies.
Reference
Refer to the “SELECT command” section in the Xerox
4050/4090/4450/4650 LPS Command Reference for instructions.
You can program the system to offset each output set
approximately 0.5 inch from the previous set.
High-capacity stitcher/stacker configuration
The stitcher/stacker tray holds up to 2,000 sheets of unstitched
paper. If you want the system to stitch your output, it is
collected inside the output module, stitched, and ejected into
the output tray. The system can stitch up to 50 sheets in each
set.
You can program the system to offset each output set
approximately 0.5 inch from the previous set.
XEROX 4050/4090/4450/4650 LPS PRODUCT REFERENCE
2-9
Summary of Contents for 4050
Page 1: ...XEROX Xerox 4050 4090 4450 4650 Laser Printing Systems Product Reference June 1994 720P93010...
Page 6: ......
Page 10: ......
Page 40: ......
