SETTING THE SYSTEM CONFIGURATION
4-16
XEROX DOCUPRINT 4850/4890 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
Setting optional processing parameters
You can set processing parameters for your system as follows:
1. Select Optional Processing Parameters from the Configuration
pull-down menu.
2. On the Optional Processing Parameters screen (refer to the
next page for an illustration), identify the parameters you want
to set.
•
Number of imagers — Specifies how many imagers to run.
An imager should be added for each CPU on the system.
•
Trace drawing commands — Enables or disables tracing
of the IPDS commands sent from PSF. These commands
result in drawing commands for the imagers.
Checking this option will degrade performance.
•
Ignore black areas — Enables or disables the WCB option.
This option removes large areas of black from IM images to
save printer consumables.
•
Use replicate and trim — Enables or disables the
Replicate and Trim option. This option is used to image
large areas by using a small area pattern supplied by the
host, and replicate the pattern to fill the large area in a tiling
manner. Enabling this option reduces the transmission time
for image data from PSF to the IPS printer. By default, this
parameter should be enabled.
•
Use alternate printer model number — Specifies the
printer model sent by the IPS printer to PSF during a Sense
Type and Model (STM) response.
•
Alternate Markform — Enables or disables the Alternate
Markform option. This option prints a printer specific mark
on the end banner sheets. Enabling this option results in a
Xerox logo. By default, this parameter is set to print a black
bar on the end banner sheets.
3. For each parameter, select the checkbox and enter the
information on the right, if applicable.
4. When all parameters are set, click Apply.
