Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language
5-53
LPI DJDE: point to note
If LARGE[ST] was specified for the LINE BASELINE parameter,
the LPI DJDE is ignored.
MAP DJDE
References a font mapping file (
FILENAME
.LIB) previously
created using a compiled SEFFNT command.
Type
Page oriented
Syntax
MAP =
FILENAME
Options
MARGIN DJDE
Specifies the left printing margin within each logical page. It
takes effect at the logical page following an END DJDE.
Type
Page oriented
Syntax
MARGIN =
value
| [
value
,
valuetype
]
lineno
line number
Specifies the line number or numbers over which the line spacing will be
applied. The options are:
•
n
Number of the line to which the specified
linespacing
will be
applied
•
n–
Number of the line from which the specified
linespacing
will be
applied through BOF (bottom of form).
•
n–m
The specified
linespacing
will be applied from line
n
through
line
m
.
Table 5-42. LPI DJDE options and definitions (Continued)
Option
Definition
Table 5-43. MAP DJDE options and definitions
Option
Definition
FILENAME
Name of the font mapping file to be used.
Summary of Contents for 6100BD - Phaser Color Laser Printer
