DOCUSP 4.1
Nuvera Stacker/Finisher Script
For the Nuvera family of printers, you must use the following
script to set up Stackers and/or Finishers:
1. Open a terminal window.
2. Login as root.
3. Type
cd /opt/XRXnps/bin/DFA_IsStacker
.
4. Press <Enter>.
5. Type
./set –f 0
OR
./set –f 1
. Use the value 0 if the
attached DFA device is a finisher, or use the value of 1 if
the attached DFA device is a stacker. Note that there are
spaces before and after the –f switch.
6. Restart DocuSP.
NOTE: This setting is lost on an upgrade or a scrape
install and must be recreated using this procedure.
LPR gateway behavior for document title
Prior to DocuSP 4.0, the controller applied the LPR gateway
filename to submitted documents as opposed to the internally
set document name. Starting with DocuSP 4.0, the controller
applies the internal document name to the job.
To set the DocuSP to the pre-4.0 behavior, run the following
script:
1. Open a terminal window.
2. Login as root.
3. Type
enablePre40LPRBehavior
4. Press <Enter>.
5. To disable the pre-4.0 LPR behavior, type
disablePre40LPRBehavior
6. Restart DocuSP.
NOTE: A document name set in the job ticket has a higher
precedence than the LPR gateway and internal document
attributes.
XEROX DOCUMENT SERVICES PLATFORM SERIES 27
GETTING STARTED
