Page 30
Web Print Manager Tool User Guide
4.
Ethernet TCP/IP Address
- These four fields contain the IP address of the Network
Interface Card on the printer’s AccXES Controller. The address is of the form "w.x.y.z"
where the range for w, x, and y is 0-255 and z is 0-254.
5.
Ethernet TCP/IP Gateway
- These fields contain the IP address of the device the printer
will use as the gateway or router. The format is the same as the Ethernet TCP/IP
Address.
For the WIDE FORMAT PRINT SYSTEMS 8855, 721P, and X2 TECH, BEFORE pressing
the Update Printer button, click on the indicated hypertext link to save a TCP/IP Recovery
file. If the Web PMT becomes unusable, you can send this recovery file to the AccXES
Controller through the serial or parallel port. For the WIDE FORMAT PRINT SYSTEMS
8825/8830/8850/ 510DP Printers, you MUST make a written record of these settings
BEFORE clicking the Update Printer button.
NOTE:
After modifying the IP Address, Subnet Mask, or Gateway, you should reboot (power
off, then power on) the AccXES Controller to use the new settings.
IPX/SPX Page (8830/8825 only)
Navigation:
PRINTER DEFAULTS > NETWORK > IPX/SPX
If you entered the printer password in the Session Setup, you can change the Novell
IPX/SPX parameters in the printer if you have the network interface card. These parameters
are described below:
1.
Enabled
- Click on this check box to enable/disable IPX/NDS on the printer.
2.
IPX Frame Type
- Click on this list box to select the IPX frame (link level) protocol.
The possible values are AUTO, 802.3, 802.2, SNAP and ETHERNET2.
3.
IPX Queue Scan Rate
- Enter the query interval in integer seconds (0-255). This
controls the frequency with which NetWare file servers are queried for print jobs.
4.
Bindery Mode (Novell 3.XX)
- Click on this radio button to enable the Bindery Mode;
the NDS Mode will be disabled.
IPX Primary Server
- Enter the name (up to 47 characters) of a preferred server (in a
Novell network). This server should hold the Novell network configuration file for the
Network Interface Card (NIC), and will be the first server searched when the NIC boots
up with the printer. If this field is blank, all servers will be searched.
NOTE:
This field cannot be blank if the Bindery Mode is currently being used. On
power-up, the NIC will search the network for the primary server that contains the
configuration file that identifies all the available print servers. This text box will be
ignored if the NDS Mode radio button is selected (see below).
5.
NDS Mode (Novell 4.XX)
- Click on this radio button to enable the NDS Mode; the
Bindery Mode will be disabled. The NDS Mode text boxes will be ignored if the NDS
Mode radio button has not been selected.
Ÿ
IPX NDS Tree
- Enter the name (up to 63 characters) of the NDS Tree to which the
NIC connects.
