October 2012
2-94
ColorQube 8570/8870 Service Manual
Tray 2 is Missing, Unload Output Tray (when not full)
Revised, 3rd Revision - Xerox Internal Use Only
Fault Messages and Codes
Tray 2 is Missing (when inserted)
A Tray 2 error has occurred. The following troubleshooting procedure applies to this error.
Initial Actions
•
Remove the tray and inspect the tray cavity to ensure that it is free of obstructions or
debris.
•
If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Part (Chapter 5 - Parts List)
•
Paper Size Switch,
PL 6.1 Item 1
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
•
Figure 5
, I/O Board P/J Locations
•
Figure 8
, I/O Board, Sensors (1 of 2)
Procedure
Check the Paper Size Switch wiring connector
P/J701
for damage or being unplugged. Is the
connection secure and undamaged?
Y
N
Reseat and/or replace the wiring harness.
Replace the Paper Size Switch (
REP 6.1
).
Unload Output Tray (when not full)
An Output Tray error has occurred. The following troubleshooting procedure applies to this
error.
Initial Actions
•
Remove all paper from the Output Tray.
•
If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts (Chapter 5 - Parts List)
•
Exit Assembly,
PL 3.1 Item 13
•
Engine Exit Flag,
PL 6.1 Item 8
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
•
Figure 1
, Right Side Wire Routing
•
Figure 8
, I/O Board, Sensors (1 of 2)
Procedure
Check the Exit Flag for free movement. Is the Flag bent, warped, or unseated?
Y
N
Check the Exit Flag wiring harness connector
P/J601
. Is the connection secure and
undamaged?
Y
N
Reseat and/or replace the wiring harness.
Replace the Exit Assembly (
REP 3.13
).
Reseat or replace the Exit Flag.
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
