October 2012
4-64
ColorQube 8570/8870 Service Manual
REP 3.13
Revised, 3rd Revision - Xerox Internal Use Only
Repairs and Adjustments
7.
Open the Exit Module.
8.
Open the Lower Exit Guide Assembly.
9.
Disconnect the Drum Temperature Sensor wiring harness connector
P/J130
.
Figure 3 Disconnecting the Drum Temperature Sensor Wiring Harness Connector
10. Remove the 4 screws (metal, T-20) that secure the Exit Module.
11.
Lift the Exit Module from the chassis.
Figure 4 Removing the Exit Module
Replacement
Seat the Exit Module on the chassis. Torque the 4 screws to 12 in.-lbs and perform Wiper
Blade Alignment procedure (
ADJ 1.1
). The printer may report errors 91,720~91,723, if the
Wiper Assembly is misaligned.
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
