October 2012
4-78
ColorQube 8570/8870 Service Manual
REP 4.10, REP 4.11
Revised, 3rd Revision - Xerox Internal Use Only
Repairs and Adjustments
REP 4.10 Head Maintenance Clutch
Parts List on
PL 4.1 Item 10
Removal
1.
Remove the Control Panel Cover (
REP 1.5
).
2.
Remove the Right Side Cover (
REP 1.11
).
3.
Disconnect the Head Maintenance Clutch wiring harness connector
P/J119
from the wir-
ing harness.
4.
Remove the KL-Clip.
5.
Remove the Head Maintenance Clutch.
Figure 1 Removing the Head Maintenance Clutch
Replacement
Perform the Homing the Printhead Forward to Print Position procedure (
ADJ 1.2
) and Process
Drive Alignment procedure (
ADJ 1.3
) before restoring printer power.
REP 4.11 X-Axis Motor
Parts List on
PL 4.1 Item 11
Removal
1.
Remove the Control Panel Cover (
REP 1.5
).
2.
Remove the Right Side Cover (
REP 1.11
).
3.
Disconnect the X-Axis Motor wiring harness connector
P/J123
from the Motor.
4.
Remove 4 screws (plastic, T-20) that secure the motor to the frame.
5.
Remove the X-Axis Motor.
Figure 1 Removing the X-Axis Motor
Replacement
Engage the fork extending from the cone-nut of the Motor Assembly with the chassis rib as
shown in
Figure 1
. Also, slip the mounting plate behind the ground strap and replace the cable
retainer on the lower right screw. Perform the Homing the Printhead Forward to Print Position
procedure (
ADJ 1.2
) and Process Drive Alignment procedure (
ADJ 1.3
) before restoring printer
power. Note, do not over tighten the screws as the holes in the chassis strip out easily.
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
