October 2012
4-93
ColorQube 8570/8870 Service Manual
REP 5.9
Repairs and Adjustments
Xerox Internal Use Only - Revised, 3rd Revision
REP 5.9 Wave Amplifier
Parts List on
PL 5.1 Item 9
Removal
WARNING
Disconnect the Power Cord before servicing the printer. Line Voltage present on the
Fuse and Fuse Holder Contacts.
CAUTION
Handle the ribbon cables carefully. Check that each cable is square to the socket and fully
inserted. Damage to the Wave Amplifier could result from improper cable connections.
1.
Remove the Control Panel Cover (
REP 1.5
).
2.
Remove the Left Side Cover (
REP 1.10
).
3.
Remove the Right Side Cover (
REP 1.11
).
4.
Remove the Exit Cover (
REP 1.7
).
5.
Remove the Ink Loader (
REP 1.8
).
6.
Manually tilt the Printhead Assembly forward (
ADJ 1.2
).
7.
Remove the Funnel Cap (
REP 2.1
).
8.
Remove the Jetstack Cap (
REP 2.2
).
9.
Remove the Ribbon Cable Retaining Clip.
Figure 1 Removing the Ribbon Cable Retaining Clip
10. Use the Unlock/Lock tool to unlock the ZIF connector
P/J240
from the Printhead Assem-
bly by gently lifting up on the ends of the connector lock as shown in
Figure 2
.
Figure 2 Printhead Cable Connections
11.
Remove the Electronics Module (
REP 5.1
).
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
