October 2012
4-100
ColorQube 8570/8870 Service Manual
REP 6.5, REP 6.6
Revised, 3rd Revision - Xerox Internal Use Only
Repairs and Adjustments
REP 6.5 Drum Temperature Sensor
Parts List on
PL 6.1 Item 5
Removal
1.
Remove the Control Panel Cover (
REP 1.5
).
2.
Remove the Right Side Cover (
REP 1.11
).
3.
Remove the Left Side Cover (
REP 1.10
).
4.
Remove the Exit Cover (
REP 1.7
).
5.
Remove the Ink Loader (
REP 1.8
).
6.
Remove the Exit Module (
REP 3.13
).
7.
Remove 1 screw that secures the Sensor to the Drum.
8.
Remove the Drum Temperature Sensor.
Figure 1 Removing the Drum Temperature Sensor
REP 6.6 Front Door and Exit Door Interlock Switches
Parts List on
PL 6.1 Item 6
Removal
1.
Remove the Control Panel Cover (
REP 1.5
).
2.
Remove the Control Panel (
REP 1.6
).
NOTE: Removal of the Outer Duplex Guide is not required to replace the Front Door
Interlock Switch.
3.
Remove the Left Side Cover (
REP 1.10
).
4.
Remove the Right Side Cover (
REP 1.11
).
5.
Remove the Outer Duplex Guide (
REP 3.4
).
6.
Disconnect the wiring harness connector
P/J116
.
7.
Remove the defective switch from the Outer Duplex Guide.
Figure 1 Removing the Exit Door and Front Door Switches
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
