October 2012
2-40
ColorQube 8570/8870 Service Manual
92,563, 92,570, 92,579, 92,571
Revised, 3rd Revision - Xerox Internal Use Only
Fault Messages and Codes
92,563, 92,570, 92,579 Electronics Module Faults
An Electronics Module error has occurred. The following troubleshooting procedure applies to
these errors.
Initial Actions
•
Reboot the printer and verify the error persists.
•
If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Part (Chapter 5 - Parts List)
•
Electronics Module,
PL 5.1 Item 1
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
•
Figure 1
, System Block Diagram
•
Figure 2
, Right Side Electronics Module P/J Locations
•
Figure 3
, Left Side Electronics Module P/J Locations
•
Figure 4
, Top Side Electronics Module P/J Locations
Procedure
Check all the Electronics Module cabling. Are the connections secure and undamaged?
Y
N
Reseat and/or replace the wiring harnesses.
Replace the Electronics Module (
REP 5.1
).
92,571 Software Fault
A software error has occurred. The following troubleshooting procedure applies to this error.
Initial Actions
•
Reboot the printer and verify the error persists.
•
Check code version of the printer.
•
If the problem persists, perform the following procedure.
Procedure
Check code version on the printer. Is the code latest release?
Y
N
Download the latest code.
Reset NVRAM (refer to
PS NVRAM Reset
in Chapter 2).
Table 1 Applicable Fault Codes
92,563
PS Version Mismatch
92,570
Interrupt Storm Fault
92,579
CDI Submit Sheet Error
Table 1 Applicable Fault Code
92,571
Software Fault
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
