October 2012
2-42
ColorQube 8570/8870 Service Manual
92,588 ~ 92,596, 92,597, 92,601
Revised, 3rd Revision - Xerox Internal Use Only
Fault Messages and Codes
92,588 ~ 92,596 Electronics Module Faults
An Electronics Module error has occurred. The following troubleshooting procedure applies to
these errors.
Initial Actions
•
Reboot the printer and verify the error persists.
•
If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Part (Chapter 5 - Parts List)
•
Electronics Module,
PL 5.1 Item 1
•
Power Supply Board,
PL 5.1 Item 6
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
•
Figure 1
, System Block Diagram
•
Figure 2
, Right Side Electronics Module P/J Locations
•
Figure 3
, Left Side Electronics Module P/J Locations
•
Figure 4
, Top Side Electronics Module P/J Locations
Procedure
Check the wiring harness connectors. Are the connections secure and undamaged?
Y
N
Reconnect the wiring harness connectors.
Replace the Power Supply Board (
REP 5.6
) (Electronics Module).
92,597, 92,601 Electronics Module Faults
An Electronics Module error has occurred. The following troubleshooting procedure applies to
these errors.
Initial Actions
•
Reboot the printer and verify the error persists.
•
If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Part (Chapter 5 - Parts List)
•
Electronics Module,
PL 5.1 Item 1
•
Power Supply Board,
PL 5.1 Item 6
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
•
Figure 1
, System Block Diagram
•
Figure 2
, Right Side Electronics Module P/J Locations
•
Figure 3
, Left Side Electronics Module P/J Locations
•
Figure 4
, Top Side Electronics Module P/J Locations
Procedure
Check all the Electronics Module cabling. Are the connections secure and undamaged?
Y
N
Reseat and/or replace the wiring harnesses.
Follow the diagnostic procedure for +50V Short Circuits (
Printer Fails Power-up: +50V LED
Does Not Illuminate
) in Chapter 6, General Troubleshooting. Is there a short circuit?
Y
N
Replace the Electronics Module (
REP 5.1
).
Repair circuit or replace the Power Supply Board (
REP 5.6
) (Electronics Module).
Table 1 Applicable Fault Codes
92,588
PS Timeout ErrTx
92,589
PS Parity ErrTx
92,590
PS Line FreqErrTx
92,591
PS Data ErrTx
92,592
PS Secure PgrmErrTx
92,593
PS Framing ErrRx
92,594
PS Parity ErrRx
92,595
PS Over Flow ErrRx
92,596
PS Comm ErrRx
Table 1 Applicable Fault Codes
92,597
PS 50 Volts Down
92,601
PS Over Voltage Watchdog Timer
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
