October 2012
2-46
ColorQube 8570/8870 Service Manual
92,808 ~ 92,813, 92,900
Revised, 3rd Revision - Xerox Internal Use Only
Fault Messages and Codes
Figure 3 Printer Ground Locations
92,900 Ink Loader Disconnect
An Ink Loader error has occurred. The following troubleshooting procedure applies to this
error.
Initial Actions
•
Reboot the printer and verify the error persists.
•
Verify the Ink Loader cable connection to the Ink Loader and Electronics Module.
•
If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts (Chapter 5 - Parts List)
•
Ink Loader & Bezel,
PL 1.1 Item 8
•
Electronics Module,
PL 5.1 Item 1
•
Power Control Board,
PL 5.1 Item 8
•
Cable, Ink Loader Data,
PL 5.1 Item 11
•
Cable, I/O Board Data,
PL 5.1 Item 14
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
•
Figure 2
, Right Side Electronics Module P/J Locations
•
Figure 5
, Ink Level Sensors, Gate Solenoids, Ink Loader Board
•
Figure 11
, Ink Loader Board P/J Locations
Procedure
Check the Ink Loader Board wiring harness connectors
P/J702
&
P/J401
. Are the connec-
tions secure and undamaged?
Y
N
Reseat and/or replace the wiring harness.
Replace the Power Control Board (
REP 5.6
) (Electronics Module.
Table 1 Applicable Fault Codes
92,900
Ink Loader Disconnect
Summary of Contents for COLORQUBE 8570
Page 1: ...ColorQube 8570 8870 Printer ColorQube 8570 8870 Service Manual Xerox Internal Use Only...
Page 2: ......
Page 423: ......
