DocuColor 240/250
DocuColor 240/250 Training and Information Guide
80
Edge Erase
The Edge Erase feature allows you to adjust the amount of the image that is
erased around the edges of your copies. For example you can remove the marks
on your copies made by drilled holes or staples in your original. This feature is
accessed from the Scan Options tab.
The Edge Erase options are shown below.
Normal
This option causes a preset amount to be erased from the edges of the output
image. This amount can be preset by the System Administrator.
Edge Erase
This option allows you to specify the amount to be erased from the top/bottom
edges, left/right edges, and the center of the output image.
Independent Edge Erase
This option allows you to independently set the amount to be erased for each of
the four edges and/or the center of your copy. The default is 0.1" and each edge
can be adjusted in 0.1" increments up to 2.0".
Border Erase
This option allows you to specify an equal amount to be erased from each of the
top, bottom, left, and right edges. The amount to be erased from the center of the
image can be also be specified.