5
5-5
Troubleshooting the DocuColor 40 CP
Frame Type selection
(Network Protocol Setup>
IPX>SPX Setup)
Can’t detect Token Ring
hardware.
Token Ring hardware
not installed or
not functioning.
DocuColor 40 CP queries the Token Ring hardware. Error
indicates that some components are not installed, are not
installed correctly, or not installed in the correct device. An
unsupported Token Ring board may be in use. Check with
your authorized service/support center.
Invalid frame size.
The network hub is not connected to a Novell machine
when the DocuColor 40 CP tries to bind.
Warning! IPX network
number is zero.
No other IPX machine can be found on the network, or
the network hub is not connected to the network, when
the DocuColor 40 CP tries to bind. When this occurs, the
network number defaults to zero.
Token Ring Setup
Can’t autodetect the ring
speed. No device on ring.
The DocuColor 40 CP is trying to detect the current ring
speed, but it is the only machine on the Token Ring
network. Connect another machine to the Token Ring
network first, before connecting the DocuColor 40 CP.
Enable NDS
(Network Service Setup>
PServer Setup > NDS Setup)
No NDS trees found.
No NDS trees were found on the Novell network. Check
to see that the frame types on the DocuColor 40 CP are
properly configured.
Select NDS Tree
(Network Service Setup >
PServer Setup>NDS Setup)
Warning! Selecting a new NDS
tree deletes Bindery setup.
You have previously connected the DocuColor 40 CP to a
different NDS tree. NetWise supports only a single NDS
tree connection. To avoid a potential conflict with an
existing tree connection (for example, if the connection
was made through a NetWare 4.x server in emulation
mode), all bindery settings will be deleted.
If you choose OK, and choose Yes in the following message
screen (
Delete Bindery setup and continue?
), bindery
settings are deleted and have to be re-entered in Bindery
Setup.
To avoid deleting the bindery settings, press the Menu key,
or select OK and choose No in the following message
screen (
Delete Bindery setup and continue?
).
Repeat NDS Setup without changing the NDS tree, or exit
to Bindery Setup to review your current bindery settings.
After this Setup screen:
This message:
Means:
