A
A-3
Token Ring Network Option
T
O
CONNECT
STP (
SHIELDED
TWISTED
PAIR
)
CABLE
TO
THE
D
OCU
C
OLOR
40 CP:
•
With the DocuColor 40 CP turned off, connect STP cable from the Token Ring MAU to
the DB-9 STP connector on the Token Ring card.
Configure the NetWare, Windows NT, or UNIX server to print to the
DocuColor 40 CP (see the next two sections). Then, proceed to page 2-2 for
DocuColor 40 CP Setup.
IPX/SPX installations
If your network uses IPX/SPX protocols with Token Ring, configure at least one
printer, a DocuColor 40 CP Print Server and a DocuColor 40 CP Print Queue on the
NetWare server as described in “Configuring a NetWare server for printing” on
page 4-4. You can configure up to eight bindery servers and one NDS tree connection
to the DocuColor 40 CP. This total is the same whether the DocuColor 40 CP is
connected by Token Ring, by Ethernet, or by both. For more information, see “Setting
up an NDS connection” on page 4-6.
TCP/IP installations
If your network uses TCP/IP protocols with Token Ring, configure a printer and a
DocuColor 40 CP queue on a Windows NT server (see “Configuring a
Windows NT 4.0 server to support the DocuColor 40 CP” on page 4-18), or on a
UNIX server (see “Setting up the DocuColor 40 CP on TCP/IP networks” on
page 4-26).
Setting up Token Ring on the DocuColor 40 CP
Token Ring Setup on the Control Panel is similar to Ethernet Setup. From Network
Setup, perform Port Setup, Protocol Setup, and Service Setup. The setups you need are
summarized in the table on page 2-11.
N
OTE
:
Connect the Token Ring cable before doing DocuColor 40 CP Network Setup,
so that the Token Ring card can configure itself properly.
