1
1-11
DocuColor 40 CP on the network
Before you begin
The following steps should be completed before you configure the DocuColor 40 CP
and the workstations that will print to the DocuColor 40 CP. A service technician will
have performed some initial installation.
T
O
PREPARE
FOR
D
OCU
C
OLOR
40 CP
CONFIGURATION
:
1.
Print a copier test page to make sure the copier is functioning normally.
2.
Turn off the copier and connect the interface cable from the copier to the
DocuColor 40 CP.
3.
To confirm this connection, turn on the copier and the DocuColor 40 CP and print a
Test Page from the Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. (See “DocuColor 40 CP Setup from the Control Panel” on
page 2-2.) Choose Print Pages, and then Test Page.
4.
With both the copier and the DocuColor 40 CP turned off, connect the network cable
to the DocuColor 40 CP, as described in the next section.
The network should already be installed and operational.
5.
Turn on the copier and then the DocuColor 40 CP.
6.
Prepare network servers to share DocuColor 40 CP user software and to enable
networked users to print to the DocuColor 40 CP, and proceed to Setup.
See Chapters 2 and 3 for details.
