2
2-19
Network Setup options
Subnet Mask
[255.255.255.0]
This option lets you modify the subnet mask for printing with TCP/IP over Token
Ring. The subnet mask is set to
255.255.255.0
by default. If you set the IP address
and you need to set the subnet mask, enter one of the following values:
•
255.0.0.0
if the IP address starts with a number less than 128.
•
255.255.0.0
if the IP address starts with a number from 128 through 191.
•
255.255.255.0
if the IP address starts with a number greater than 191.
N
OTE
:
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from those
listed.
Gateway
If your TCP/IP network has a gateway, and users outside the gateway plan to print
to the DocuColor 40 CP using TCP/IP, choose Gateway Setup and enter the
gateway address here.
The gateway address applies to either a Token Ring or an Ethernet network. If
TCP/IP is running on both an Ethernet and a Token Ring network, the gateway
address you enter must be in the same subnet as either the Ethernet or the Token
Ring address.
Network Setup
Protocol Setup
TCP/IP Setup
Gateway Setup
Gateway Address
[127.0.0.1]
Use this option to set the gateway address for printing with TCP/IP. By default, the
loopback address, 127.0.0.1, is set. (The loopback address is a specially reserved
address that allows for certain TCP/IP diagnostic tests to be run without being
connected to a network.)
After setting the gateway address, proceed to setup Token Ring, if applicable, or
choose Exit TCP/IP Setup and proceed to Service Setup.
Exit TCP/IP Setup
Ethernet Setup
Token Ring Setup
Gateway Setup
TCP/IP Setup
