USAGE GUIDELINES
DocuColor 40 MATERIALS USAGE GUIDE
19
Steps for Success
1
Run all label materials from the Paper Tray Bypass with the face
side up.
2
Select Heavy Weight Paper Mode.
3
Fan the stacks before loading for optimum feeding.
4
If a jam occurs and a damaged or folded lead edge is found,
manually curl the lead edge down before loading to minimize future
jamming.
Hints, Tips and Testing Results
Xerox testing has shown the following:
•
When recommended materials are run as detailed above; with
the correct tray, mode, and orientation, feeding performance
and image quality is good, but will not equal 24 lb Image Series
LX / 90 g/m
2
Colotech performance.
•
Toner saturation on electronic originals should be limited to a
total of 240% (60% for each Color). Higher toner saturations
can result in poorly fused prints and damage to the fuser.
•
In general, successful labels should have a low-weight face and
backing sheet, and should have a pattern-printed adhesive.
CAUTION:
Dry gum labels (those that require moistening before
being applied) can cause severe machine contamination problems
and should not be used.
12 3. . .
Summary of Contents for DocuColor 40
Page 57: ......
