27
Using the Fiery XJ utilities for the first time
Using the Fiery XJ utilities for the first time
In order to use the Fiery XJ utilities, certain files must be moved to specific locations
and configured to connect to the Fiery XJ.
Windows 3.1x
Where to move and how to configure files depends on your network connection. You
must do the following:
• Move the Fiery XJ utility files to the appropriate locations (if you have older files
that will be rewritten, rename or back them up).
• Verify that you have the correct information in your NET.CFG file. This file was
installed as part of your installation of IPX/SPX.
T
O
MOVE
FILES
TO
THE
APPROPRIATE
LOCATIONS
:
1.
Open the folder containing the Fiery XJ utilities.
2.
Open the IPXSPX folder and move files to the following locations:
*This is the default NET_WSCK.INI file. You or your system administrator must
customize it for your site as described in “Configuring the NET_WSCK.INI file” on
page 28.
T
O
VERIFY
THE
INFORMATION
IN
THE
NET.CFG
FILE
FOR
W
INDOWS
3.1
X
AND
IPX:
•
In the Link Driver section of the file, make sure that the Ethernet Frame Type matches
what is set on your Fiery XJ.
You can print the Configuration page from the Fiery XJ Control Panel to see the
current setting.
Windows 95 and Windows NT
You may need to configure the NET_WSCK.INI file before the Fiery XJ utilities will
connect to the Fiery XJ (see “Configuring the NET_WSCK.INI file” on page 28).
From this folder:
Drag these files:
To this location (path):
IPXSPX\SYSTEM
All files
WINDOWS\SYSTEM folder
IPXSPX\WINDOWS
NET_WSCK.INI*
WINDOWS folder