DOCUSP 3.74
4-4
XEROX DOCUMENT SERVICES PLATFORM SERIES
GETTING STARTED
Caveat
Applicable printer product
The system may display an unclearable Reset
message. The system prints normally.
DocuTech/DocuPrint 75/90
When Offset stacking is enabled, stitched jobs
do not offset.
DocuTech 61xx
During a Print Now or Proof, a message to
“Remove Sheets from the Top Tray” may be
displayed when there is no need to remove
sheets. Always clear the message before
performing any other operation.
DocuTech 61xx
When a job is printing to the top tray and is
interrupted by a print now or proof job, the
interrupted job stops (as it should) and an
error message reads, "remove sheets from
top tray". Whether the sheets are removed or
not, the message stays until "reset" is selected
in the fault frame.
DocuTech 61xx
External finishing cannot be selected at the
client using the IPP or HTTP gateways.
Submit the job to the printer without any
finishing, and select the external finisher at the
DocuSP.
DocuPrint 1xx EPS
DocuTech 61xx
The DocuSP software cannot read any LPS
formatted floppy disk on the Sun Blade 2500
external USB floppy drive. Use a QIC tape or
DOS formatted floppy to import LCDS
resources to the system.
DocuPrint 1xx EPS
A large job that requires partitioning on a
system set for user intervention hangs when
the user responds to the intervention message
to print 1 copy.
DocuPrint 1xx EPS
For multi-copy jobs, if an OTEXT command is
specified on a copy pass for a page that
doesn't print (no data on the page), then the
OTEXT message will not be displayed and the
WAIT parameter will be ignored.
DocuPrint 1xx EPS
The system is unable to resume printing when
late binding attributes and page spacing
options are used. As a work around, restart
the DocuSP or Select Sample Current job
from the Printer drop down menu to activate
the resume and sample button on the
repositioning output dialog box and the
Resume button on the DocuSP main window.
DocuPrint 1xx EPS
The list of supported MIBs documented in the
Document Services Platform Common
Controller System Guide
are incorrect. Refer
to the section on SNMP at the end of this
chapter for more information.
All
