DOCUSP 3.74
5-6
XEROX DOCUMENT SERVICES PLATFORM SERIES
GETTING STARTED
Label the next cassette “Vol 2,” insert it into the tape drive, then
enter
yes
. This message set is repeated for as many tapes as
required to complete the backup.
IMPORTANT:
Proper labeling of the tape is essential to a
successful recovery. As the system requests additional
tape cartridges, be sure to label the tapes in the correct
sequence (for example, Vol #1, Vol #2, etc.). If you insert
the tapes in the wrong order during the recovery, the
restoration fails.
NOTE: Due to the current DocuSP licensing protection scheme,
tapes can be restored only to the system from which they were
backed up. In other words, tapes from one system cannot be
used to "clone" another system. Any attempt to do this will
invalidate the DocuSP license, and a full reloading of software
will be required to make the system operational.
If you have multiple printing systems, it is recommended that
tapes be labeled with the hostname of the system to reduce the
possibility of restoring to the wrong system.
Testing the backup tape
The following procedure enables you to check if the backup tape
contains valid data.
1. Ensure that the tape drive is connected and powered on.
Insert the backup tape in the tape drive. If the backup
required more than one cassette, make sure that the first
tape (Vol 1) is inserted.
2. Open a Terminal window and logon as
root
user.
3. Enter
mt -f /dev/rmt/0 status
to check the tape drive status.
The system returns a message indicating the type of tape
drive.
If the system generates the error message
/dev/rmt/0: no
such file or directory
, enter
mt -f /dev/rmt/1 status
. If
the error message is displayed again, repeat steps 1 through 3
of the “Checking the tape drive" procedure, described later in
this chapter. If the problem persists, call for service.
4. When the tape drive location has been verified, enter the
following command:
ufsrestore tvf /dev/rmt/
x
bn"
where
x
is either 0 or 1, depending on the value that you used
in step 3. After a few seconds, the system starts displaying the
contents of the tape cassette.
To stop the scrolling display, press <CTRL-c>. When prompted
to discontinue the display, enter
y
.
