1
31
Installing Scanner on Scanner Stand
This section explains how to remove the scanner from the shipping box
and install it.
Always have two persons or more to carry the scanner. This scanner weighs
25.2 kg/55.56 lbs. When lifting the scanner, have the persons facing each
other from the right and left sides of the printer (assuming the part with the
control panel is the front) Grasp the parts shown in the illustration. Never
try to lift the scanner while holding any other parts. Otherwise there is a
severe risk of injury if the scanner is dropped. When lifting the scanner,
correct posture is important to prevent hip injuries.
This procedure should have been carried out for you by the delivery per-
sonnel when you purchased the scanner. Therefore, you can skip to the
“1.1.4 Connecting the cables” section.
(1) Remove the scanner from the shipping box and install it.
The scanner is to be placed on the scanner stand, remove the black rubber
pegs on the front feet. Lower the scanner onto the scanner stand so that the
scanner’s front feet go into the square recessed areas on the stand, and the
back feet go into the round recessed areas on the stand.
Save the removed rubber pegs by inserting them into the storage openings
on the rear side of the stand. The rubber pegs are required when you need
to transport the scanner over a long distance or if you need to install the
scanner at a location different from the scanner stand.
1.4 Installation Procedure
Summary of Contents for DocuColor DocuColor 4
