Maintenance
Xerox
®
DocuMate
®
3125
User Guide
6-11
Descriptions of the most common patterns are listed below. In all cases, you should turn off the
scanner and check the scanner setup. Make sure the USB cable is plugged into the scanner and
computer. Make sure the power cord is plugged into the scanner and into a wall outlet. Contact
Xerox Technical Support if you experience a different blinking pattern.
Xerox® DocuMate® 3125 Specifications
Error
Code
Problem Description
Solution
0
Scanner is not connected to
the computer. (The LED does
not flash “E” and the status
light remains blue.)
A cable may be loose. Check that the scanner’s cables are
correctly attached to the computer. If the scanner still does not
connect, re-boot the computer.
4
Paper jam
Open the ADF cover and remove the jammed page. See
“Clearing Paper Jams” on page 2.
5
Multiple paper feed
Multiple pages have fed through the scanner at one time.
Open the ADF door and remove the pages from the scanner.
Make sure the pages are not stuck or taped together before
loading them in the ADF. If the problem persists, clean the
double feed detection sensor as described on the previous
section.
6
The scanner’s cover is open.
The ADF door is not closed all the way. Open the scanner then
close it again. Push down on the lid until it locks into place.
All
Other
Codes
An internal part in the
scanner may have
malfunctioned.
Turn off the power to your scanner, then turn it back on. If the
problem persists, re-boot your computer. If the problem still
persists, contact Xerox Technical Support.
Scanner Specifications
Document Requirements
Minimum Item Size
3 x 2 inches (76 x 51 mm)
Maximum Item Size
8.5 x 38 inches (216 x 965 mm)
Capacity
50 pages of 20lb printer paper (75–80 g/m
2
)
Paper Thickness
13–32 lbs. (49–120 g/m
2
)
Plastic Card
Embossed cards up to 1.25 mm thick
General Specifications
Scanning Speeds
38 pages per minute / 66 images per minute @ 200 dpi
Optical Resolution
600 dpi
Output Bit Depth
24-bit color, 8-bit grayscale, 1-bit bitonal (black & white)
Scan Method
Duplex Automatic Document Feeder (ADF)
Image Sensor
Dual CIS (Contact Image Sensor)
Light Source
Dual RGB LED lamps
Interface
Hi-Speed USB 2.0, compatible with USB 1.1
Certifications
UL, C-UL, FCC Class B, CE, WEEE, RoHS, E
NERGY
S
TAR
Operating Temperature
50° ~ 95° F (10° ~ 35° C without condensation)