Maintenance
Xerox
®
DocuMate
®
4830
User Guide
6-7
2.
Squeeze the plastic clamp that holds the pad assembly in place.
3.
Lift the pad up and out of the scanner.
4.
Remove the tension spring that is located under the ADF pad.
5.
Place the new tension spring in the scanner.
6.
Place the new ADF pad in the scanner on top of the tension spring.
7.
Press down on the ADF pad until you hear a "click" when it locks in place.
8.
Close the scanner when you’re finished.
Replacing the Feed Roller
The roller will wear out and is designed to be a user-replaceable part. A worn roller can cause
documents to feed in skewed at an angle, or multiple pages to feed at the same time. Before
replacing the roller you should clean it as excessive dust on the roller will make it appear worn and
smooth. You cannot properly diagnose a worn roller until you have cleaned it. You should generally
replace the roller every 160,000 to 200,000 scans.
