DocuMate 515 Scanner User’s Guide
13
Installation
Step 4: Connect the USB Cable and Turn on the Power
The DocuMate 515 scanner connects to any available USB port. Check
your computer’s manual for USB port locations.
1.
Remove any protective tape from the USB cable.
2.
Plug the USB cable into the USB port on the scanner then into a USB
port on the computer.
If the plug does not attach easily, make sure that you are plugging it in
correctly. Do not force the plug into the connection.
3.
Turn on the power switch, located on the back of the scanner to the
right of the power port.
The status light comes on and flashes indicating that the scanner is
receiving power.
If you are using Windows XP or Windows Vista, and have plugged the
USB cable into a USB 1.1 port, an information bubble may open
explaining that “A HI-SPEED USB device is plugged into a non-HI-
SPEED USB hub”. Plug the USB cable into a USB 2.0 port (if
available) or just disregard the message. If you leave it plugged into
the USB 1.1 port, your scanner may scan a bit slower.
4.
Your computer recognizes that a scanner has been plugged into the
USB port and automatically loads the appropriate software to run the
scanner.
If your computer is running Windows XP or Windows Vista, you will
see a message similar to the following.
USB
Summary of Contents for DocuMate 515
