Xerox 490/980 Color Continuous Feed Printing System
Prepare for Color Calibration
Color Management Guide
3-11
Check for Queue and Imposition Files
The purpose of this section is to determine if any of the imposition files or queues used in
chapter 4 have already been created.
The following procedures explain how to check for pre-existing imposition files and queues.
Check for Existing Imposition Files
A new imposition file is required only if the paper stock is being changed. An imposition file may
have already been created to accommodate the new paper stock width. The following
procedure explains how to check for existing imposition files.
1.
Ensure that the Xerox 490/980 Color Continuous Feed Printing System is powered on and is
connected to the PC-UI.
2.
Select [
Resource Management
] on the left-side navigation pane of the PC-UI.
3.
Look for any imposition files that are named with the following convention:
•
Simplex_PreCal_
[Paper Stock Width]
Note
As an example, if you were changing to 18 in (457 mm) width paper stock, you would look
for an imposition file called [
Simplex_PreCal_18in
].
4.
If you find an imposition file that has the width of paper stock you are using, you can skip
the
Set Up Imposition Files
section of Chapter 4.
5.
If you do not find an imposition file that has the width of paper stock that you are using,
you must perform the
Set Up Imposition Files
section of Chapter 4.
Check for Existing Queues
A new queue is required only if the paper stock width is being changed. A queue may have
already been created to accommodate the new paper stock width. The following procedure
explains how to check for existing queues.
1.
Ensure that the Xerox 490/980 Color Continuous Feed Printing System is powered on and is
connected to the PC-UI.
2.
Select [
Queue Management
] on the left-side navigation pane of the PC-UI.
3.
Look for any imposition files that are named with the following convention:
•
TRC
_
[Paper Stock Width]
Note
As an example, if you were changing to 19.5 in (495 mm) width paper stock, you would look
for a queue called [
TRC_19-5in
].
4.
If you find a queue that has the width of paper stock you are using, you can skip the
Create
a New Queue
section of Chapter 4.
5.
If you do not find a queue that has the width of paper stock that you are using, you must
perform the
Create a New Queue
section of Chapter 4.
Summary of Contents for Document Centre 480
Page 1: ...Xerox 490 980TM Color Continuous Feed Printing System Color Management Guide 27 October 2008 ...
Page 2: ......
Page 101: ......
