3-10
Sending a Fax
Memory Transmission (Broadcasting)
With Memory Transmission (Memory TX), documents are stored in
memory and automatically sent to one or more remote stations. Use this
feature to send your documents to multiple locations.
You can store a maximum of ten fax numbers for a memory transmission. If
you need to send your fax to more than ten locations, you can increase the
number of fax locations dialed by including a Group Dial number as one of
the ten numbers.
After sending, the documents are automatically erased from memory.
1
Adjust the document guides to match the width of the document.
2
Slide the document face down into the Automatic Document Feeder
until it is grasped and pulled into the machine.
If necessary, adjust the resolution and contrast. For details, see
Resolution on page 3-23 and Contrast on page 3-25.
3
Press the Menu button, then press the Memory TX button on the One-
Touch keypad.
4
Enter the telephone number of the remote machine. There are several
methods available to do this:
Direct entry of the telephone number using the numeric keypad.
One-Touch keypad dialing of stored telephone numbers (see One-
Touch Dialing on page 3-16).
Speed Number dialing using the numeric keypad (see Speed
Dialing on page 3-19).
Print the 480cx User Guide
Summary of Contents for Document WorkCentre 480cx
