R u n n i n g T E L N E T
5-48
❖
D o c u P r i n t 4 5 1 2 / 4 5 1 2 N N e t w o r k I n t e r f a c e C a r d U s e r G u i d e
4. To end your
Telnet
session, type
E
at the Main Menu. If
you have made any changes you are prompted to either
Save Changes and Exit
or
Exit Without Saving Changes
.
Choose your option and press
.
Configure IP
Parameters
Although the NIC must have an IP address before a
Telnet
Connection can be made, you can use the utility to change
the address or the other IP parameters. The NIC will
automatically initiate a soft reset when the IP address change
is sensed.
1. At the Main Menu, type
1
and press
to bring up the
IP
Parameters menu (shown on the next page).
1. IP Parameters
2. LPD Printers
3. Protocols
4. Restore Factory Defaults
5. Change Password
E. Exit
Note
Press ? to access the Telnet help utility.
Note
This will cause the Telnet connection to be broken. It is
advisable to make all other desired changes before changing
the IP address.
Book.frm : CHAP5.FRM Page 48 Saturday, October 12, 1996 7:43 AM
