SYSTEM CONTROL TASKS
Turn off Attention light or alarm
Use this task to turn off the Attention light. Neither the steady
nor flashing modes of the Attention light operate, and the Hint
and Fault icons do not appear on the PC UI and the printer
control console. When the next fault condition occurs, the
Attention light and appropriate icons appear again.
Turn off Attention Light task through
windows
Select the appropriate Disabled button(s) as follows:
Steady Light:
Select this button to disable the Steady
Attention light located on top of the printer.
Alarm:
Select this button to disable the audible alarm.
Flashing Light:
Select this button to disable the Flashing
Attention light located on top of the printer.
Turn off Attention Light task through
command line
Enter the following command:
ATTENTION ALL OFF
Energy saver
To conserve energy and prolong the life of some of its critical
parts, the LPS was designed with a power saver mode. After a
predetermined period of inactivity, portions of the printer are
shut down. The time-out period is factory set, but it can be
readjusted.
Heating and cooling are the most costly uses of electricity.
Therefore, maintaining the system at full temperature while idle is
not cost effective. After four hours of inactivity (or whatever
time period you set), the fusing system shuts down. Once it
cools down, it requires the same four- to seven-minute warm-up
time as if the system had been turned off.
Use the Energy Saver task to readjust the time-out period. The
energy saver timer starts whenever the printer stops.
Energy Saver task through windows
1. Select “Energy Saver” from the System Control menu to open
the Energy Saver window.
Figure 4-12.
Energy Saver window
4-12
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
