FreeFlow Process Manager Operator and Administrator Guide
2-92
Workflow Builder
•
[
PDF Bleed Box
] to define the amount of extra area to
image outside of the final page size defined by the PDF
Trim Box.
•
[
PDF Art Box
] to define the area of the page where PDF
content is placed.
For more information about PDF boxes, see
PDF Page
Box Considerations
and
PDF Page Box Limitations
.
NOTE:
Bleed, Trim, and Art boxes must be smaller than or
equal to the defined PDF Crop Box.
5. In the crop marks offsets area, specify offsets from the edges
of the selected crop mark box:
•
[
Top
], [
Bottom
], [
Left
], and [
Right
] to set the desired
offsets.
•
[
Uniform
] to define all offsets; defined by the Top offset.
•
[
Inward offset
] to place offsets inside the perimeter of the
selected box.
•
[
Outward offset
] to specify offsets outside the perimeter
of the selected box.
NOTE:
The Outward offset option is disabled for media sheet
crop marks.
Offsets must be all inward or all outward. Negative offset
values are not allowed.
NOTE:
For the PDF box options, the above options define the
box relative to the size of the PDF page being imposed. The
box is affected by and moved according to all transformations
of the page such as Autofit, Margin, and Page Image Position/
Alignment settings. The range is 0 to 60 inches and the metric
equivalent.
Use care with this option as it is possible to specify a box
rectangle that exceeds the actual page size or that is clipped
off by the sheet cell(s) during imposition.
Summary of Contents for FreeFlow
