Introduction
ix
Safety notes
Your system has been designed and tested to meet strict safety
requirements. These include safety agency examination and
approval plus compliance with established environmental standards.
WARNING: Failure to follow the recommendations in this
section may result in personal injury or rescinding of the
machine operation agreement.
Maintenance safety
1. Follow all warnings and instructions marked on or supplied with
the product.
2. Unplug the units from the wall outlet before cleaning the exterior.
Always use materials specifically designated for the MAX 200.
Use of other materials may result in poor performance and could
create a hazardous situation.
3. Do not use aerosol cleaners. Follow the instructions in this
operator guide for the correct cleaning methods.
4. Never use supplies or cleaning materials for purposes other than
what they were intended. Keep all supplies and materials out of
the reach of children.
5. Do not use the units near water, wet locations, or outdoors.
6. The components of this product are equipped with a three-wire,
grounding-type plug (i.e., a plug having a grounding pin). This
plug will only fit into a grounding-type power outlet. This is a
safety feature. To avoid the risk of electric shock, contact your
electrician to replace the receptacle if you are unable to insert the
plug into the outlet.
7. Never use a ground adapter plug to connect the system to a
power source that lacks a ground connection terminal.
8. This system should be operated from the type of power source
indicated on the marking label. If you are not sure of the type of
power available, consult your local power company.
9. The power supply cord is the disconnect device for this
equipment. Make sure that the installation is near the socket
outlet and is easily accessible.
10. Do not allow anything to rest on the power cord. Do not locate
the units where someone will step on the cord.
11. The units should not be placed in a built-in installation unless
correct ventilation is provided.
