Maintenance
72
Xerox Card Scanner 200 User’s Guide
5. Place the cleaning sheet in the scanner.
The scanner pulls in the cleaning sheet. The scanner will move the cleaning sheet back and forth during
cleaning.
6. When cleaning is complete the scanner will eject the sheet out of the scanner. Do not forcefully pull the
sheet out, the scanner will release the sheet when it has fully exited out of the scanner.
Cleaning from the Windows Control Panel:
If you did not install One Touch during the initial installation of the scanner driver, see page 8, please
follow these steps to open the scanner’s hardware properties.
NOTE:
If you are using Windows 2000 or Windows Vista 64-bit, please see “Calibrating or Cleaning the
Scanner from TWAIN” on page 64. All other supported versions of Windows can use these intructions or
the ones in the TWAIN section.
1. Open the Windows Control Panel.
2. Double-click on
Scanners and Cameras
.
If you do not see Scanners and Cameras, open Printers and Other Hardware then you should see this
option.
3. Your Xerox Card Scanner 200 should be listed as one of the attached scanners. Right-click on the
scanner and choose Properties to open the Device Settings for your scanner.
4. You can now follow the steps in this section to clean the scanner.
Summary of Contents for Nuvera 200
