Service Parts Disassembly
8-41
Reassembly Notes
Note
When reinstalling the Duplex Guide Plate, make sure the plate is past the
flange before you reinstall the springs.
Note
Be sure that you reinstall the ground wire on the right side of the Duplex
Guide Plate.
Tray 2 Pick Roller (PL 9.3.67.3)
1.
Remove the Tray 2 Paper Pick Assembly (page 8-36).
2.
Remove the spring (release from the shaft) on the left side of the pick roller shaft.
Caution
Be careful not to drop the spring during removal.
3.
Remove the bearing on the right end of the pick roller shaft and slide the end of
the shaft to the right to disengage the shaft coupling.
4.
Pull the center shaft out of the retaining clips.
5.
Pull the segmented roller off of the roller core.
6.
Slide the new segmented roller on to the roller core and reassemble the Paper
Pick Assembly by reversing the previous steps..
-
Summary of Contents for Phaser 3425
